Enable Portfast on Cisco switch port
Switch>en
Switch#conf t
Switch(config)#int fa 0/24 (interface number)
Switch(config-if)#spanning-tree portfast
%Warning: portfast should only be enabled on ports connected to a single
host. Connecting hubs, concentrators, switches, bridges, etc... to this
interface when portfast is enabled, can cause temporary bridging loops.
Use with CAUTION
%Portfast has been configured on FastEthernet0/24 but will only
have effect when the interface is in a non-trunking mode.
Switch(config-if)#do wr
Building configuration...
[OK]
Switch(config-if)#exit
 |
| Portfast CLI command |
This notes are for everyone, who will find them helpful.
Comments, questions, corrections are Welcome.
0 Comments